• Plug in the device power cord and connect it to a router via an ethernet cable.
  • Note: If you have a corporate firewall, please ensure the following:
    • Allow outbound https port 443 traffic to tripos.vantiv.com
    • Allow TCP/IP traffic to port 9001 of device.tripos.vantiv.com
  • When the device displays an activation code it is ready to pair.
    • If the activation code does not appear on the device screen, try resetting your device by holding down # and the yellow button
• Click on the circle account button in the top right corner of your screen, then select “System Settings” from the dropdown menu.

• In System Settings, go to the "EMV Devices" tab under the “Payment” section. 

• Ensure that the correct location is selected. The location is displayed in the top right half of the screen.
• Hit the + icon in the top right corner of the table

• Enter a display name, terminal ID, lane ID (this can be any number between 1-99), and the activation code displayed on the device
  • If the device supports signature, check the “Supports Signature” checkbox in the bottom right corner of the pop-up.
• Verify that all information is correct and then click the "Save" button

To test the device:

• Navigate to the "Rental Search" tab under the "Counter" section

• Click the + button at the top right corner of the table to create a walk-in rental contract

• Select “Yes” when prompted with the screen below

• Make sure the pickup location is the location that you used to set up the EMV device

• Go through the checkout steps until you reach the “Payment Information” section.
• Hit the + button at the top right corner of the table to create a new payment ledger

• Select the "Swipe Card" option
• Choose a transaction type (Sale/Auth)
• Choose the payment type (Total + Deposit, Total Amount, Deposit, Other)
• Choose the lane you just setup
• Hit the save button

• Complete the transaction on the EMV device